Fuel Receiver Gauge Malfunction [08/2017 - 08/2018]: Procedure

1. Using the Techstream, perform the Active Test.

   Refer to DATA LIST / ACTIVE TEST [08/2017 - 08/2019]

   COMBINATION METER:
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Fuel Meter Operation	Fuel receiver gauge	OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full or Sender F	Perform the test with the vehicle stopped and engine idling

   OK

   Fuel receiver gauge indication is normal.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2017 - ] 

Result: 

OK 

See step  2

1. Using the Techstream, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [08/2017 - 08/2019]

   COMBINATION METER:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Fuel Level	Fuel sender gauge input/Min.: 0, Max.: 127.5	Fuel sender input value	Unit: L

   Result

   Result	Proceed to
   Fuel level data displayed on the Techstream is almost the same as the fuel receiver gauge indication.	A
   Fuel level data displayed on the Techstream differs from the fuel receiver gauge indication.	B

Result: 

B 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2017 - ] 

Result: 

A 

See step  3

1. *1: for 3UR-FE
2. *2: for 3UR-FBE

1. Disconnect the J28 combination meter assembly connector.
2. Disconnect the R6*1 or R19*2 fuel sender gauge assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   FOR 3UR-FE
   
   

   Tester Connection	Condition	Specified Condition
   J28-26 (L) - R6-2	Always	Below 1 Ω
   J28-25 (E3) - R6-3
   J28-24 (ES) - Body ground
   J28-26 (L) or R6-2 - Body ground or other terminal	Always	10 kΩ or higher
   J28-25 (E3) or R6-3 - Body ground or other terminal

   FOR 3UR-FBE
   
   

   Tester Connection	Condition	Specified Condition
   J28-26 (L) - R19-2	Always	Below 1 Ω
   J28-25 (E3) - R19-3
   J28-24 (ES) - Body ground
   J28-26 (L) or R19-2 - Body ground or other terminal	Always	10 kΩ or higher
   J28-25 (E3) or R19-3 - Body ground or other terminal

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Remove the fuel sender gauge assembly.

   Refer to REMOVAL [08/2015 - 08/2018]

2. Inspect the fuel sender gauge assembly.

   Refer to INSPECTION [08/2015 - 08/2018]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2017 - ] 

Result: 

NG 

REPLACE FUEL SENDER GAUGE ASSEMBLY. Refer to  REMOVAL [08/2015 - 08/2018]