Fuel Receiver Gauge Malfunction [08/2015 - 08/2017]: Procedure

1. Check the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
   RESULT
   
   

   Result	Proceed to
   DTC B1500 is not output	A
   DTC B1500 is output	B

Result: 

B 

GO TO DTC B1500 

(Refer to DTC B1500: Fuel Sender Open Detected [08/2015 - 08/2017] )

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream ON.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. According to the display on the Techstream, perform the Active Test.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Fuel Meter Operation	Fuel receiver gauge	EMPTY, 1/2 or FULL	-

   OK

   Needle indication is normal.

Result: 

OK 

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2017] )

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2017] )