Entire Combination Meter does not Operate [08/2017 - 08/2019]: Procedure

1. Disconnect the H139 combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance and voltage according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H139-24 (ES) - Body ground	Always	Below 1 Ω

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   H139-1 (B) - Body ground	Always	11 to 14 V
   H139-2 (IG+) - Body ground	Ignition switch ON	11 to 14 V

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [08/2017 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR