Caution / Notice / Hint
NOTE:
- Perform fluid replacement with the parking brake applied.
- Perform fluid replacement while maintaining the brake fluid level between the MIN/MAX level on the brake fluid reservoir.
- Do not allow brake fluid to contact the vehicle's paint surfaces. If contact occurs, clean it off immediately.
- Make sure there is sufficient brake fluid in the can.
- After adding brake fluid, make sure the reservoir is sufficiently full.
- When bleeding air, select the suitable procedure listed below.
Replaced/Installed Item Work Procedure Flexible hose (front/rear) Bleed brake line Disc brake cylinder assembly (front/rear) Brake actuator assembly Bleed brake system Brake master cylinder sub-assembly Brake master cylinder reservoir assembly Brake booster assembly