Television Display Power Source Circuit [08/2017 - 08/2019]: Procedure

1. Disconnect the television display assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   U13-17 (GND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   U13-1 (+B) - Body ground	Always	11 to 14 V
   U13-2 (ACC) - Body ground	Ignition switch ACC	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Television Display Assembly)

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR