A Remote Control System does not Operate [08/2015 - 08/2019]: Procedure
- CLEAN INFRARED RAY EMITTING PORTION
- Clean the infrared ray emitting portion.
- Clean the infrared ray emitting portion on the rear display.
- Check whether the same malfunction occurs.
OK
The function returns to normal.
Result:
OK
END
Result:
NG
See step 2
- Clean the infrared ray emitting portion.
- CHECK REAR SWITCH AND VOLUME ASSEMBLY (DRY-CELL BATTERY)
- Check that the dry-cell battery of the rear switch and volume assembly is not depleted.
OK
Battery is not depleted.
Result:
NG
REPLACE REAR SWITCH AND VOLUME ASSEMBLY (DRY-CELL BATTERY)
Result:
OK
See step 3
- Check that the dry-cell battery of the rear switch and volume assembly is not depleted.
- CHECK REAR SWITCH AND VOLUME ASSEMBLY
- Temporarily replace the rear switch and volume assembly with a new or known good one.
- Check that the television display assembly can be operated using the rear switch and volume assembly.
OK
The television display assembly can be operated.
Result:
OK
END (REAR SWITCH AND VOLUME ASSEMBLY WAS DEFECTIVE)
Result:
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
(Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019] )