LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Exterior) - Diagnostic Codes & Circuit Tests >> Lighting System >> Turn Signal Switch Circuit [08/2017 - ] >> Procedure

Turn Signal Switch Circuit [08/2017 - ]: Procedure

  1. READ VALUE USING TECHSTREAM 
    1. Using the Techstream, read the Data List.

      Refer to DATA LIST / ACTIVE TEST [08/2017 - 08/2019] , or refer to DATA LIST / ACTIVE TEST [08/2019 - ]

      COMBINATION METER

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Turn Signal Switch (Right) Turn signal switch (right) signal / OFF or ON OFF: Turn signal switch (right) off
      ON: Turn signal switch (right) on
      -
      Turn Signal Switch (Left) Turn signal switch (left) signal / OFF or ON OFF: Turn signal switch (left) off
      ON: Turn signal switch (left) on
      -
      Turn Switch Signal (Full Turn) Turn signal switch signal / OFF or ON OFF: Turn signal switch off
      OFF: Turn signal switch on (Full Turn)
      Displays for both right and left turns.

      OK

      Normal conditions listed above are displayed.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [08/2017 - 08/2019]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2019 - ] 

    Result: 

    NG 

    See step  2

  2. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY 
    1. Remove the headlight dimmer switch assembly.

      Refer to REMOVAL [08/2017 - ]

    2. Inspect the headlight dimmer switch assembly.

      Refer to INSPECTION [08/2017 - 08/2019] , or refer to INSPECTION [08/2019 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY. Refer to  REMOVAL [08/2017 - ] 

    Result: 

    OK 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND) 
    1. Disconnect the H11 headlight dimmer switch assembly connector.
    2. Disconnect the H139 combination meter assembly connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      H11-14 (CR) - H139-28 (SW) Always Below 1 Ω
      H11-13 (TR) - H139-17 (ER) Always Below 1 Ω
      H11-15 (TL) - H139-16 (EL) Always Below 1 Ω
      H11-12 (EL) - Body ground Always Below 1 Ω
      H11-14 (CR) or H139-28 (SW) - Body ground Always 10 kΩ or higher
      H11-13 (TR) or H139-17 (ER) - Body ground Always 10 kΩ or higher
      H11-15 (TL) or H139-16 (EL) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2017 - ] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR