Inspection [08/2017 - ]: Procedure
- INSPECT HEADLIGHT ASSEMBLY LH
- Apply battery voltage to the connector and check the light illumination condition.
OK
Battery Connection Specified Condition Positive (+) → 6(B)
Negative (-) → 5(E)Parking light illuminates Positive (+) → 7(B)
Negative (-) → 5(E)Daytime running light illuminates Positive (+) → 2(LO)
Negative (-) → 5(E)Low beam illuminates Positive (+) → 1(HI)
Negative (-) → 5(E)High beam illuminates Positive (+) → 4(B)
Negative (-) → 5(E)Turn signal light illuminates If the result is not as specified, replace the headlight assembly LH.
*a Component without harness connected
(Headlight Assembly LH)
- Apply battery voltage to the connector and check the light illumination condition.
- INSPECT HEADLIGHT ASSEMBLY RH
- Apply battery voltage to the connector and check the light illumination condition.
*a Component without harness connected
(Headlight Assembly RH)OK
Battery Connection Specified Condition Positive (+) → 6(B)
Negative (-) → 5(E)Parking light illuminates Positive (+) → 7(B)
Negative (-) → 5(E)Daytime running light illuminates Positive (+) → 2(LO)
Negative (-) → 5(E)Low beam illuminates Positive (+) → 1(HI)
Negative (-) → 5(E)High beam illuminates Positive (+) → 4(B)
Negative (-) → 5(E)Turn signal light illuminates If the result is not as specified, replace the headlight assembly RH.
- Apply battery voltage to the connector and check the light illumination condition.