Disassembly [11/2018 - ]: Procedure

1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lever hole cover from the upper console panel sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protective Tape

   NOTE:

   Be careful not to damage the shift lever hole cover and upper console panel sub-assembly.

HINT: 

Only perform this procedure when replacement of the shift position indicator is necessary.

1. Disengage the clamp to disconnect the wire harness.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Disengage the 2 claws and 3 screws to remove the shift position indicator from the upper console panel sub-assembly.

1. Disengage the 4 claws and 2 guides to remove the lower position indicator housing from the shift lock control unit assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Do not damage the lower position indicator housing.