Installation [11/2018 - 08/2020]: Procedure
- INSTALL STEERING PAD SWITCH ASSEMBLY
- Engage the 4 claws and 3 guide pins to install the steering pad switch assembly.
- Install the 2 screws.
- Connect the connectors to the spiral cable sub-assembly.
- INSTALL STEERING WHEEL PAD ASSEMBLY
Refer to INSTALLATION [11/2018 - 08/2020]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- for A25A-FKS: Refer to PROCEDURE - Step 2
- for A25A-FXS: Refer to PROCEDURE - Step 2
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [11/2018 - 02/2019] , or refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]
- CHECK SRS WARNING LIGHT
- w/ Occupant Classification System: Refer to OPERATION CHECK [11/2018 - 02/2019] , or refer to OPERATION CHECK [02/2019 - 08/2020]
- w/o Occupant Classification System: Refer to OPERATION CHECK [11/2018 - 08/2020]