LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> Maintenance >> Procedures >> Maintenance - Service Information (2 Of 2) >> A25A-FXS Auxiliary Battery >> Installation [08/2020 - ] >> Procedure

Installation [08/2020 - ]: Procedure

  1. INSTALL AUXILIARY BATTERY 
    1. w/ No. 1 Battery Spacer:

      Install the No. 1 battery spacer.

    2. Install the auxiliary battery.
    3. Install the battery clamp sub-assembly with the bolt and nut.

      Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

    4. Connect the battery hose to the auxiliary battery.
    5. Connect the cable to the positive (+) auxiliary battery terminal and tighten the nut.

      Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

    6. Close the connector cover.
  2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

      Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Refer to INITIALIZATION [08/2020 - 12/2021] , or refer to INITIALIZATION [12/2021 - 10/2022] , or refer to INITIALIZATION [10/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]

  3. INSTALL BATTERY HOLE COVER 
    1. Attach the 12 claws and install the battery hole cover.
  4. INSTALL REAR NO. 2 FLOOR BOARD 
    1. Attach the 2 clips and 2 guides and install the luggage trim service hole cover.
  5. INSTALL DECK BOARD ASSEMBLY 
    1. Install the deck board assembly.
scientia non olet · About LEMON Manuals