Installation [11/2018 - ]: Procedure

HINT: 

When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.

1. Set the V-ribbed belt onto each pulley as shown in the illustration.
   Fig 1: Engine Drive Belt Routing Diagram (A25A-FKS)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Crankshaft Pulley Assembly
   *2	Generator Assembly
   *3	Compressor Assembly With Pulley

2. Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.
3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Correct
   *b	Incorrect

Refer to PROCEDURE - Step 98 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 98 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 98 [12/2021 - ]