LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Hybrid Battery Control System - Service Information (6 Of 7)) >> Accelerator Pedal Sensor >> On-Vehicle Inspection [02/2019 - ] >> Procedure

On-Vehicle Inspection [02/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Hybrid Control / Data List / Accelerator Position Sensor No. 1 Voltage %, Accelerator Position Sensor No. 2 Voltage %.

      Powertrain > Hybrid Control > Data List 

      Tester Display
      Accelerator Position Sensor No. 1 Voltage %
      Accelerator Position Sensor No. 2 Voltage %
    5. Read the Data List.

      Result

      Tester Display Accelerator Pedal Condition Specified Condition
      Accelerator Position Sensor No. 1 Voltage % Not depressed 10 to 22%
      Fully depressed 52 to 90%
      Not depressed → Fully depressed → Not depressed (Accelerator pedal should be operated slowly) Value changes progressively
      Accelerator Position Sensor No. 2 Voltage % Not depressed 24 to 40%
      Fully depressed 68 to 99%
      Not depressed → Fully depressed → Not depressed (Accelerator pedal should be operated slowly) Value changes progressively
scientia non olet · About LEMON Manuals