Removal [08/2020 - 12/2021]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE SERVICE PLUG GRIP
Refer to REMOVAL [08/2020 - 12/2021]
- DISCONNECT ENGINE ROOM MAIN WIRE
Refer to PROCEDURE - Step 4
- REMOVE CONNECTOR COVER ASSEMBLY
Refer to PROCEDURE - Step 9
- CHECK TERMINAL VOLTAGE
Refer to PROCEDURE - Step 10
- INSTALL CONNECTOR COVER ASSEMBLY
Refer to PROCEDURE - Step 6
- CONNECT ENGINE ROOM MAIN WIRE
Refer to PROCEDURE - Step 31
- REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 2
- REMOVE REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 8
- REMOVE NO. 3 BATTERY SERVICE COVER BOARD
See step 4
- REMOVE REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
- REMOVE NO. 2 BATTERY SERVICE COVER BOARD
See step 6
- REMOVE BATTERY SERVICE COVER BOARD
See step 7
- REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
See step 8
- REMOVE NO. 1 HV BATTERY COVER PANEL RH
Refer to PROCEDURE - Step 9
- REMOVE ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY WARNING:
Be sure to wear insulated gloves and protective goggles.
- Disconnect the electric vehicle battery plug assembly connector.
*A for Type A *B for Type B - for Type A:
Disengage the 2 claws and open the wiring harness protector.
- for Type B:
Disengage the claw and open the wiring harness protector.
- for Type A:
- Disconnect the HV battery junction block assembly connector.NOTE:
Insulate the disconnected high-voltage connector with insulating tape.
- Disconnect the hybrid battery terminal block connector.NOTE:
Insulate the disconnected high-voltage connector with insulating tape.
- Remove the bolt and electric vehicle battery plug assembly from the HV battery.
- Disconnect the electric vehicle battery plug assembly connector.