Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during oil pump with solenoid assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Oil pump with solenoid assembly | Check the oil pump with solenoid assembly | Stop and start system | Refer to REGISTRATION [11/2018 - 10/2019] , or refer to REGISTRATION [10/2019 - 12/2021] , or refer to REGISTRATION [12/2021 - 10/2022] , or refer to REGISTRATION [10/2022 - 10/2023] , or refer to REGISTRATION [10/2023 - ] |