Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

NOTE:

Before troubleshooting, make sure that the "Kick Sensor Function" customize setting is set to "ON" (The default is "ON").
Refer to CUSTOMIZE PARAMETERS [11/2018 - 10/2023]
Before troubleshooting, be sure to read Precautions for Hands Free Power Back Door.
Refer to PRECAUTION [11/2018 - 10/2023]
If the multiplex network door ECU has been removed and installed or replaced, or if any of the connectors has been disconnected, initialize the power back door system.
Refer to INITIALIZATION [11/2018 - 10/2023]
After performing work, using the Techstream, read the Data List item "Kick Sensor Connection" and check that the kick door control sensor is connected.
Refer to DATA LIST / ACTIVE TEST [11/2018 - 10/2023]
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
This check is possible only when the power back door function customization setting using the multi-information display in the combination meter assembly is set to ON (initial setting is ON).
Refer to CUSTOMIZE PARAMETERS [11/2018 - 10/2023]