DTC B2205: Kick Sensor Circuit [11/2018 - 10/2023]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2023]

   Body Electrical > Back Door > Clear DTCs 

2. Wait for approximately 60 seconds.
3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2023]

   Body Electrical > Back Door > Trouble Codes 

   OK

   DTC B2205 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ] 

Result: 

NG 

See step  2

1. Disconnect the Q7 kick door control sensor connector.
2. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2023]

   Body Electrical > Back Door > Clear DTCs 

3. Wait for approximately 60 seconds.
4. Check for DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2023]

   Body Electrical > Back Door > Trouble Codes 

   OK

   DTC B2205 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE KICK DOOR CONTROL SENSOR. Refer to  REMOVAL [11/2018 - 02/2019]  , or refer to  REMOVAL [02/2019 - 10/2019]  , or refer to  REMOVAL [10/2019 - 08/2020]  , or refer to  REMOVAL [08/2020 - 12/2021]  , or refer to  REMOVAL [12/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023] 

Result: 

NG 

See step  3

1. Disconnect the R18 multiplex network door ECU connector.
2. Disconnect the Q7 kick door control sensor connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   R18-14 (KSIN) or Q7-3 (KSOT) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MULTIPLEX NETWORK DOOR ECU. Refer to  REMOVAL [11/2018 - 10/2023] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR