Electric Parking Brake ECU Communication Stop Mode [11/2018 - 02/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR OPEN IN CAN BUS WIRE (PARKING BRAKE ECU ASSEMBLY BRANCH WIRE)
- Disconnect the cable from the negative (-) auxiliary battery terminal.
- Disconnect the parking brake ECU assembly connector.
*a Front view of wire harness connector
(to Parking Brake ECU Assembly) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition M35-11 (CANH) - M35-1 (CANL) Cable disconnected from negative (-) auxiliary battery terminal 54 to 69 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE CAN BRANCH WIRE OR CONNECTOR
Result:
OK
See step 2
- CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
- Disconnect the parking brake ECU assembly connector.
*a Front view of wire harness connector
(to Parking Brake ECU Assembly) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition M36-9 (GND1) - Body ground Cable disconnected from negative (-) auxiliary battery terminal Below 1 Ω - Reconnect the cable to the negative (-) auxiliary battery terminal.NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [11/2018 - 02/2019]
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Switch Condition Specified Condition M36-7 (+B) - Body ground Power switch off 11 to 14 V M36-12(+B2) - Body ground Power switch off 11 to 14 V M35-3(BECU) - Body ground Power switch on (IG) 11 to 14 V Power switch off Below 1 V M35-5 (IG) - Body ground Power switch on (IG) 11 to 14 V Power switch off Below 1 V Result
Proceed to OK NG
Result:
OK
REPLACE PARKING BRAKE ECU ASSEMBLY
Refer to REMOVAL [11/2018 - 02/2019]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
- Disconnect the parking brake ECU assembly connector.