Combination Meter ECU Communication Stop Mode [02/2019 - 10/2022]: Description
WARNING: This page is about a different variant/trim than selected.
| Detection Item |
Symptom |
Trouble Area |
| Combination Meter ECU Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Combination Meter" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [02/2019 - 06/2020]
, or refer to PROBLEM SYMPTOMS TABLE [06/2020 - 08/2020]
, or refer to PROBLEM SYMPTOMS TABLE [08/2020 - 12/2021]
, or refer to PROBLEM SYMPTOMS TABLE [12/2021 - ]
- Communication stop history for "Combination Meter" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Combination Meter" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [02/2019 - 06/2020]
, or refer to PROBLEM SYMPTOMS TABLE [06/2020 - 08/2020]
, or refer to PROBLEM SYMPTOMS TABLE [08/2020 - 12/2021]
, or refer to PROBLEM SYMPTOMS TABLE [12/2021 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [02/2019 - 10/2019]
, or refer to DTC COMBINATION TABLE [10/2019 - 06/2020]
, or refer to DTC COMBINATION TABLE [06/2020 - 08/2020]
, or refer to DTC COMBINATION TABLE [08/2020 - 12/2021]
, or refer to DTC COMBINATION TABLE [12/2021 - 10/2022]
|
- Combination meter assembly main wire or connector
- Power source circuit of combination meter assembly
- Combination meter assembly ground circuit
- Combination meter assembly
|