On-Vehicle Inspection [11/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Put the engine in Inspection Mode (Maintenance Mode).
Powertrain > Hybrid Control > Utility
Tester Display Inspection Mode - Check the PCV valve (ventilation valve sub-assembly) operation.
- Start the engine.
- Slide the clip and disconnect the No. 2 ventilation hose from the air cleaner hose assembly.
- Check that air is sucked into the No. 2 ventilation hose.
Standard
Air is sucked into the No. 2 ventilation hose.
If the result is not as specified, replace the PCV valve (ventilation valve sub-assembly).