Removal [02/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY
Refer to REMOVAL [02/2019 - 08/2020] , or refer to REMOVAL [08/2020 - 12/2021] , or refer to REMOVAL [12/2021 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
REMOVE REAR FLOOR SERVICE HOLE COVER
Refer to PROCEDURE - Step 15 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 15 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 15 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 15 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 15 [10/2023 - ]

REMOVE FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR)

Disconnect the fuel tank pressure sensor (vapor pressure sensor) connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the tube joint clip and pull off the fuel tank pressure sensor (vapor pressure sensor) from the fuel tank assembly.

*1	Fuel Tank Pressure Sensor (Vapor Pressure Sensor)
*2	Fuel Suction Plate Sub-assembly
*3	Tube Joint Clip
*a	O-ring

NOTE:

Remove any dirt or foreign matter on the fuel tank pressure sensor (vapor pressure sensor) before performing this work.
Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tank pressure sensor (vapor pressure sensor) has an O-ring that seals the fuel suction plate sub-assembly.
Perform this work by hand. Do not use any tools.
If the fuel suction plate sub-assembly and fuel tank pressure sensor (vapor pressure sensor) are stuck, carefully wiggle or push and pull the fuel tank pressure sensor (vapor pressure sensor) to release it. Pull the fuel tank pressure sensor (vapor pressure sensor) off the fuel suction plate sub-assembly carefully.