Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedures	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Replacement of inverter with converter assembly	Resolver learning	DTCs are stored Slight vibration at a vehicle speed of 5 km/h (3 mph) or less Shock or vibration during acceleration	for 2WD: Refer to UTILITY [11/2018 - 08/2020] for AWD: Refer to UTILITY [02/2019 - ]
Gas leak from exhaust system is repaired	Inspection After Repair	Poor idle, etc. Engine start function, etc.	w/ Canister Pump Module: Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020] w/o Canister Pump Module: Refer to INITIALIZATION [11/2018 - 08/2020]