DTC U1000: CAN Communication Failure (Message Registry) [11/2018 - 10/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FOR DTC

Clear the DTCs.
Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs

Check for DTCs.

Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes

DTC U1000 is not output.

Result

Proceed to
OK
NG

HINT:

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

Refer to PROBLEM SYMPTOMS TABLE [11/2018 - 10/2022]

Result:

USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]

Result:

REPLACE PARKING ASSIST ECU. Refer to REMOVAL [11/2018 - 10/2022]