"CHK" message(s) are displayed on the SIGNAL CHECK screen. [11/2018 - 02/2019]: Description
WARNING: This page is about a different variant/trim than selected.
On the Signal Check screen, it is possible to check if the signals sent to the parking assist ECU are normal.
Refer to DIAGNOSIS SYSTEM [11/2018 - 10/2022]
HINT:
- On the Signal Check screen, "OK" (blue) is displayed for items with a normal inspection result or input state.
- On the Signal Check screen, "CHK" (red) is displayed for items with an abnormal inspection result or input state.
- Displayed items may differ depending on vehicle specifications.
| Item | Signal Input Method | Detail | DTC Output when Abnormal Result is Displayed | Signal Receiver |
|---|---|---|---|---|
| CAN | CAN communication | CAN communication signal | DTC is output | Related ECUs |
| CAMERA SW | Vehicle wire harness | Panoramic view monitor switch signal input state | DTC is not output | Panoramic view monitor switch |
| SHIFT | Vehicle wire harness | Shift position signal input state | DTC is not output | Park/Neutral position switch assembly |
| MIRROR SW* | Vehicle wire harness | Outer rear view mirror assembly signal input state | DTC is not output | Outer rear view mirror assembly |
- *: w/ Retract Mirror