DTC Summary

WARNING: This page is about a different variant/trim than selected.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory	Note
P2418-7F	Evaporative Emission System Switching Valve Control Circuit Actuator Stuck Off	Following condition is met during key-off EVAP monitor: EVAP pressure change when vent valve closed (on) less than 0.3 kPa [0.04 psi]	Canister pump module (reference orifice, leak detection pump, vent valve) Connector/wire harness (Canister pump module - ECM) Canister (filter inside canister clogged) ECM	Comes on	DTC stored	SAE Code: P2420

DTC No.	Monitoring Item	Detection Timing	Detection Logic	SAE Code
P2418-7F	Vent valve stuck open (vent)	EVAP monitoring (ignition switch off)	2 trip	P2420

HINT:

The vent valve is built into the canister pump module.