LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 132 (Engine Mechanical System (A25A-FXS) - Service Information (2 Of 6)) >> Engine Assembly >> Components [08/2020 - ]

Components [08/2020 - ]

WARNING: This page is about a different variant/trim than selected.
Fig 1: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (1 Of 13)
GTY889582Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 BATTERY HOLE COVER *2 NEGATIVE AUXILIARY BATTERY TERMINAL
*3 DECK BOARD ASSEMBLY *4 REAR NO. 2 FLOOR BOARD
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) - -
Fig 2: Engine Assembly Replacement Components [08/2020 - ] (2 Of 13)
GTY944154Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*1 BATTERY SERVICE HOLE COVER *2 SERVICE PLUG GRIP
Fig 3: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (3 Of 13)
GTY1002318Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*A for Type A *B for Type B
*C for Short Type *D for Long Type
*1 FRONT FENDER APRON SEAL LH *2 FRONT FENDER APRON SEAL RH
*3 FRONT FENDER FRONT SPLASH SHIELD LH *4 FRONT FENDER FRONT SPLASH SHIELD RH
*5 NO. 1 ENGINE UNDER COVER *6 NO. 2 ENGINE UNDER COVER ASSEMBLY
*a Short Type Front Fender Front Splash Shield *b Long Type Front Fender Front Splash Shield
N.m (kgf/cm, ft.lbf): Specified torque - -
Fig 4: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (4 Of 13)
GTY944271Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 FRONT BUMPER ASSEMBLY *2 FRONT BUMPER NO. 2 REINFORCEMENT
*3 FRONT LOWER BUMPER ABSORBER *4 HEADLIGHT ASSEMBLY LH
N.m (kgf/cm, ft.lbf): Specified torque - -
Fig 5: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (5 Of 13)
GTY927676Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE *2 INLET AIR CLEANER ASSEMBLY
*3 INVERTER RESERVE TANK ASSEMBLY *4 INVERTER WITH CONVERTER ASSEMBLY
*5 NO. 1 ENGINE COVER SUB-ASSEMBLY - -
N.m (kgf/cm, ft.lbf): Specified torque - -
Fig 6: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (6 Of 13)
GTY926539Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 FUEL TUBE SUB-ASSEMBLY *2 INLET HEATER WATER HOSE
*3 NO. 1 COOLER REFRIGERANT DISCHARGE HOSE *4 NO. 1 FUEL VAPOR FEED HOSE
*5 NO. 1 RADIATOR HOSE *6 NO. 2 RADIATOR HOSE
*7 NO. 5 INVERTER COOLING HOSE *8 NO. 5 WATER BY-PASS HOSE
*9 OUTLET HEATER WATER HOSE *10 SUCTION HOSE SUB-ASSEMBLY
*11 WIRE HARNESS *12 NO. 1 FUEL PIPE CLAMP
*13 NO. 2 RELAY BLOCK COVER *14 O-RING
N.m (kgf/cm, ft.lbf): Specified torque • Non-reusable part
Compressor oil ND-OIL 11 or equivalent - -
Fig 7: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (7 Of 13)
GTY855456Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 ENGINE UNDER COVER HEAT INSULATOR *2 FRONT EXHAUST PIPE ASSEMBLY
*3 FRONT FLOOR COVER LH *4 FRONT FLOOR COVER RH
*5 GASKET - -
N.m (kgf/cm, ft.lbf): Specified torque • Non-reusable part
Fig 8: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (8 Of 13)
GTY901499Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 FRONT AXLE SHAFT NUT LH *2 FRONT DRIVE SHAFT ASSEMBLY LH
*3 FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH *4 FRONT SPEED SENSOR LH
*5 FRONT STABILIZER LINK ASSEMBLY LH *6 TIE ROD ASSEMBLY LH
*7 FRONT FLEXIBLE HOSE *8 FRONT STABILIZER BAR
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) • Non-reusable part
Toyota Body Grease W Do not apply lubricants to the threads
Fig 9: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (9 Of 13)
GTY851640Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 FRONT DRIVE SHAFT ASSEMBLY LH *2 FRONT DRIVE SHAFT ASSEMBLY RH
*3 FRONT DRIVE SHAFT HOLE SNAP RING *4 FRONT DRIVE SHAFT OIL SEAL LH
*5 FRONT DRIVE SHAFT OIL SEAL RH - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) • Non-reusable part
MP grease Toyota Genuine ATF WS
Toyota Genuine Oil Seal Side Lip Grease - -
Fig 10: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (10 Of 13)
GTY866817Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 ENGINE ASSEMBLY WITH TRANSAXLE *2 STEERING INTERMEDIATE SHAFT ASSEMBLY
*3 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH *4 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH
*5 REAR FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY LH *6 REAR FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY RH
*7 ENGINE MOUNTING STAY LH - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) N.m (kgf/cm, ft.lbf): Specified torque
Fig 11: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (11 Of 13)
GTY1001649Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 NO. 1 ENGINE HANGER *2 NO. 2 ENGINE HANGER
*3 ENGINE WIRE *4 FLYWHEEL HOUSING UNDER COVER
*5 FRONT ENGINE MOUNTING INSULATOR *6 FRONT FRAME ASSEMBLY
*7 FUEL DELIVERY GUARD *8 HV AIR CONDITIONING WIRE
*9 REAR ENGINE MOUNTING INSULATOR *10 WIRING HARNESS CLAMP BRACKET
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) N.m (kgf/cm, ft.lbf): Specified torque
Fig 12: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (12 Of 13)
GTY1002710Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 FLYWHEEL HOUSING SIDE COVER *2 FLYWHEEL SUB-ASSEMBLY
*3 HYBRID VEHICLE TRANSAXLE ASSEMBLY *4 NO. 1 CRANKSHAFT POSITION SENSOR PLATE
*5 STARTER HOLE INSULATOR *6 TRANSMISSION INPUT DAMPER ASSEMBLY
N.m (kgf/cm, ft.lbf): Specified torque • Non-reusable part
Adhesive 1324 * Precoated part
Fig 13: Engine Assembly Replacement Components With Torque Specifications [08/2020 - ] (13 Of 13)
GTY872899Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Callout Description Callout Description
*1 ECM *2 ENGINE MOUNTING INSULATOR SUB-ASSEMBLY LH
*3 ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH *4 ENGINE MOUNTING SPACER
*5 NO. 1 INVERTER RESERVE TANK BRACKET *6 RADIATOR RESERVE TANK ASSEMBLY
*7 NO. 2 GROUND WIRE *8 ENGINE ROOM MAIN WIRE
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) N.m (kgf/cm, ft.lbf): Specified torque
scientia non olet · About LEMON Manuals