Precaution [02/2019 - 10/2023]
WARNING: This page is about a different variant/trim than selected.
- PRECAUTION WHEN USING TECHSTREAM
- After all DTCs are cleared, check if the malfunction occurs again 6 seconds after turning the ignition switch to ON.
- PRECAUTIONS FOR THE DOOR CONTROL TRANSMITTER ASSEMBLY
- The door control transmitter assembly is a precision instrument. Be sure to observe the following:
- Do not drop or strike the door control transmitter assembly.
- Do not allow the door control transmitter assembly to be kept in a high temperature place for a long time.
- Do not use an ultrasonic washing machine to clean the door control transmitter assembly.
- Keep the door control transmitter assembly away from magnets or magnetized items during use.
- Do not attach any stickers to the door control transmitter assembly.
- The door control transmitter assembly is a precision instrument. Be sure to observe the following:
- PRECAUTION FOR REGISTRATION
- If replacing any of the following parts, refer to the Registration.
Refer to REGISTRATION [02/2019 - 10/2022] , or refer to REGISTRATION [10/2022 - ]
NOTE:Any door control transmitter assemblies or ECUs for which registration has been performed cannot be reused.
- Door control transmitter assembly
- Transponder key ECU assembly
- Hybrid vehicle control ECU assembly
- If replacing any of the following parts, refer to the Registration.