Installation [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE OIL LEVEL SENSOR
1. Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.
  Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
2. Install a new clip to the engine oil level sensor.
3. Connect the engine oil level sensor connector.
INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Refer to PROCEDURE - Step 12 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 12 [02/2019 - 06/2020] , or refer to PROCEDURE - Step 12 [06/2020 - 08/2020] , or refer to PROCEDURE - Step 12 [08/2020 - 11/2024] , or refer to PROCEDURE - Step 12 [11/2024 - ]
ADD ENGINE OIL
Refer to PROCEDURE - Step 5 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 5 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 5 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 5 [10/2023 - ]
INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 6 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 6 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 6 [10/2023 - ]
CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 1 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 1 [08/2020 - 10/2023] , or refer to PROCEDURE - Step 1 [10/2023 - ]
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 65 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 65 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 65 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 65 [12/2021 - ]
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 66 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 66 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 66 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 66 [12/2021 - ]
INSTALL FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 68 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 68 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 68 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 68 [12/2021 - ]
INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 67 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 67 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 67 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 67 [12/2021 - ]