LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 120 (Fuel System (A25A-FXS) - Service Information (2 Of 2)) >> FUEL SENDER GAUGE ASSEMBLY (w/o Canister Pump Module) >> Installation [11/2018 - 08/2020] >> Procedure

Installation [11/2018 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Attach the claw and install the fuel sender gauge assembly.
    2. Attach the 2 clamps and connect the wire harness.
      NOTE:

      Do not damage the wire harness.

    3. Attach the clamp and connect the wire harness.
      NOTE:

      Do not damage the wire harness.

    4. Connect the 2 connectors to the fuel suction plate sub-assembly.
  2. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY 

    Refer to INSTALLATION [11/2018 - 08/2020] 

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2018 - 02/2019] , or refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]

  4. INSTALL BATTERY HOLE COVER 

    Refer to PROCEDURE - Step 3

  5. INSTALL REAR NO. 2 FLOOR BOARD 

    Refer to PROCEDURE - Step 4

  6. INSTALL DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 5

scientia non olet · About LEMON Manuals