Removal [12/2021 - 10/2022]: Procedure
WARNING: This page is about a different variant/trim than selected.
- DRAIN ENGINE COOLANT (for Engine)
Refer to PROCEDURE - Step 1
- REMOVE INTAKE MANIFOLD
Refer to REMOVAL [08/2020 - ]
- DISCONNECT NO. 2 RADIATOR HOSE
Refer to PROCEDURE - Step 37
- REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
- Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.NOTE:
- Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.
- Do not damage the water inlet with thermostat sub-assembly.
HINT:
When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.
- Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.
- Remove the gasket from the water inlet with thermostat sub-assembly.
- Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.