Removal [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

SECURE VEHICLE

Fully apply the parking brake and chock a wheel.

WARNING:

Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE CONSOLE BOX ASSEMBLY
Refer to REMOVAL [11/2018 - 12/2021] , or refer to REMOVAL [12/2021 - ]

REMOVE NO. 1 CONSOLE BOX DUCT

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the clip and No. 1 console box duct.

DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

NOTE:

Before disconnecting the transmission control cable assembly, check that the shift lever is in N.

Disconnect the transmission control cable assembly from the transmission floor shift assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Pull out the cable locks of the transmission control cable assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Counterclockwise
*b	Cable Lock

Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.

REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

Disconnect the transmission control switch connector.

Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.

Disconnect the shift lock control ECU connector.

Disengage the 2 clamps to disconnect the wire harness from the transmission floor shift assembly.

Remove the 4 bolts and transmission floor shift assembly.