LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 109 (Parking Support Brake System (HV) - Diagnostics - Introduction) >> PARKING SUPPORT BRAKE SYSTEM (for HV Model) >> DTC Check / Clear [02/2019 - ] >> DTC Check / Clear [02/2019 - ]

DTC Check / Clear [02/2019 - ]

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the parking support brake system on.
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical / Clearance Warning / Trouble Codes.
    6. Check for DTCs.

      Body Electrical > Clearance Warning > Trouble Codes 

      NOTE:

      The clearance warning ECU assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the parking support brake system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

      System Proceed to
      Intuitive Parking Assist System Refer to DIAGNOSTIC TROUBLE CODE CHART [02/2019 - 12/2021] , or refer to DIAGNOSTIC TROUBLE CODE CHART [12/2021 - 10/2023] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2023 - ]
  2. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the parking support brake system on.
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical / Clearance Warning / Trouble Codes.
    6. Clear the DTCs.

      Body Electrical > Clearance Warning > Clear DTCs 

scientia non olet · About LEMON Manuals