LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 108 (Motor Generator Control System (AWD, W/ Nickel Metal Hydride Battery) - Diagnostic Codes (4 Of 5)) >> MOTOR GENERATOR CONTROL SYSTEM (for AWD with NICKEL METAL HYDRIDE BATTERY) >> DTC P0E51-2A: DC/DC Converter Current Sensor Signal Stuck In Range [02/2019 - ] >> Description

DTC P0E51-2A: DC/DC Converter Current Sensor Signal Stuck In Range [02/2019 - ]: Description

WARNING: This page is about a different variant/trim than selected.

For a description of the boost converter.

Refer to DESCRIPTION 

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0E51-2A DC/DC Converter Current Sensor Signal Stuck In Range The value of the reactor current sensor does not change.
(1 trip detection logic)
  • HV battery junction block assembly
  • Inverter with converter assembly
  • Service plug grip
  • HV floor under wire
  • Hybrid vehicle control ECU assembly
  • PCU fuse
  • Wire harness or connector
 Comes on Master Warning:
Comes on
scientia non olet · About LEMON Manuals