DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [02/2019 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC OUTPUT (HEALTH CHECK)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: System Select / Health Check.
- Check for DTCs.
Result
Result Proceed to P062F-44 is output from the motor generator control system. A P062F-44 is output from any system other than the motor generator control system. B - Turn the ignition switch off.
Result:
A
REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS. Refer to DTC CHECK / CLEAR [02/2019 - ]
Result:
B
GO TO PERFORM DIAGNOSIS FOR RESPECTIVE SYSTEM