DTC P06DA-13: Engine Oil Pressure Control Circuit Open [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT OIL PRESSURE CONTROL VALVE ASSEMBLY
- Inspect the oil pressure control valve assembly.
Refer to INSPECTION [11/2018 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE OIL PRESSURE CONTROL VALVE ASSEMBLY. Refer to REMOVAL [11/2018 - ]
Result:
OK
See step 2
- Inspect the oil pressure control valve assembly.
- CHECK HARNESS AND CONNECTOR (OIL PRESSURE CONTROL VALVE ASSEMBLY - ECM)
- Disconnect the oil pressure control valve assembly connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C22-1 (OCV+) - C45-21 (VOP+) Always Below 1 Ω C22-2 (OCV-) - C45-20 (VOP-) Always Below 1 Ω C22-1 (OCV+) or C45-21 (VOP+) - Body ground and other terminals Always 10 kΩ or higher C22-2 (OCV-) or C45-20 (VOP-) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [08/2020 - 12/2021] , or refer to REMOVAL [12/2021 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR