LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Engine Control System (A25A-FXS) - Diagnostic Codes (08 Of 11)) >> SFI System >> DTC P0630-51: VIN Not Programmed [08/2020 - ] >> Procedure

DTC P0630-51: VIN Not Programmed [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630-51) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Trouble Codes.
    5. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      NOTE:

      If P0630-51 is output, the VIN must be written to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN is written. If DTCs other than P0630-51 are output, troubleshoot them first.

      Result

      Result Proceed to
      DTC P0630-51 is output A
      DTC P0630-51 and other DTCs are output B

    Result: 

    GO TO DTC CHART 

    Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2020 - 12/2021] , or refer to DIAGNOSTIC TROUBLE CODE CHART [12/2021 - 10/2022] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2022 - 11/2024] , or refer to DIAGNOSTIC TROUBLE CODE CHART [11/2024 - ]

    Result: 

    See step  2

  2. WRITE VIN 
    1. Write the VIN.

      Refer to REGISTRATION [08/2020 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    END