LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Control System (A25A-FXS) - Diagnostic Codes (04 Of 11)) >> SFI System >> DTC P0335-2A: Crankshaft Position Sensor "A" Signal Stuck in Range; DTC P0335-31: Crankshaft Position Sensor "A" No Signal [08/2020 - ] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
ALL

Both of the following conditions are met -
Hybrid control module judge Engine running
Lost communication with hybrid vehicle control ECU assembly (U0293) Not detected
P0335 (CASE 1)

All of the following conditions are met -
Auxiliary battery voltage Higher than 6 V
Crankshaft position sensor voltage 0.3 to 4.7 V
Ignition switch On
P0335 (CASE 2)

All of the following conditions are met -
Auxiliary battery voltage Higher than 6 V
Crankshaft position sensor voltage 0.3 to 4.7 V
Starter Off
Engine speed (Top dead center) 600 rpm or higher
Engine speed (30°CA) 600 rpm or higher