LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 XLE, FWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Engine Starting System (A25A-FKS) - Service Information >> Relay >> Inspection [12/2021 - ] >> Procedure

Inspection [12/2021 - ]: Procedure

  1. INSPECT ST NO. 1 RELAY (STARTER RELAY ASSEMBLY) 
    1. Check the resistance.
      GTY329933Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the ST No. 1 relay.

scientia non olet · About LEMON Manuals