Removal [11/2018 - 10/2019]: Procedure

DRAIN ENGINE COOLANT
Refer to PROCEDURE - Step 1
REMOVE INTAKE MANIFOLD
Refer to REMOVAL [11/2018 - 02/2019] , or refer to REMOVAL [02/2019 - 08/2020]
REMOVE GENERATOR ASSEMBLY
- for 100 A, 130 A Type:
  Refer to REMOVAL [11/2018 - 10/2019]
- for 150 A Type:
  Refer to REMOVAL [11/2018 - 10/2019]
- for VALEO Made:
  Refer to REMOVAL [11/2018 - 10/2019]

DISCONNECT NO. 2 RADIATOR HOSE

Slide the clip and disconnect the No. 2 radiator hose from the water inlet with thermostat sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Disconnect the water inlet with thermostat sub-assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.
Do not damage the water inlet with thermostat sub-assembly.

HINT:

When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.

Remove the gasket from the water inlet with thermostat sub-assembly.