Adjustment [11/2018 - ]: Procedure

1. Adjust the hood position.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Loosen the 4 hinge bolts on the hood and adjust the hood position.
   2. Move the hood and adjust the clearance between the hood and front fender.
   3. Tighten the 4 hinge bolts on the hood after the adjustment.

      Torque: 13 N.m (133 kgf/cm, 10 ft.lbf) 

2. Adjust the cushion rubbers so that the hood and fender are aligned.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Raise or lower the front end of the hood by turning the cushion rubber.

3. Adjust the hood lock.
   Fig 1: Hood Lock Bolts Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Loosen the 3 bolts.
   2. Adjust the hood lock position so that the striker can enter it smoothly.
   3. Tighten the 3 bolts after the adjustment in the order shown in the illustration.

      Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

Refer to ON-VEHICLE INSPECTION [11/2018 - ]