LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine Control System (A25A-FXS) - Diagnostic Codes (11 Of 11)) >> SFI System >> DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [08/2020 - ] >> Description

DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [08/2020 - ]: Description

WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC P0010-01.

Refer to DTC P0010-01: Camshaft Position "A" Actuator Bank 1 General Electrical Failure [08/2020 - ]

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P2614-01 Camshaft Position Signal Output "A" General Electrical Failure Malfunction in rotation sensor of cam timing control motor with EDU assembly is detected for 3 seconds (1 trip detection logic).
  • Cam timing control motor with EDU assembly
  • ECM
Comes on DTC stored
  • SAE Code: P2614
  • DTC for Mexico Models: Applies
SYMPTOMS AND FAIL-SAFE OPERATION DURING CAMSHAFT CONTROL MOTOR MALFUNCTION

Vehicle Condition Fail-Safe
  • Engine difficult to start
  • Lack of power
The cam timing control motor with EDU assembly is operated to the most retarded position.