LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> RAV4 Adventure >> Repair and Diagnosis >> Body & Frame >> Windows >> Window / Glass - Service Information (1 Of 2) >> POWER WINDOW REGULATOR MOTOR (for Front Door) >> Removal [08/2020 - 12/2021] >> Procedure

Removal [08/2020 - 12/2021]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Refer to PRECAUTION [08/2020 - ]

    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [11/2018 - ]

  2. REMOVE DECK BOARD ASSEMBLY (for HV Model) 

    Refer to PROCEDURE - Step 2

  3. REMOVE NO. 2 REAR FLOOR BOARD (for HV Model) 

    Refer to PROCEDURE - Step 3

  4. REMOVE BATTERY HOLE COVER (for HV Model) 

    Refer to PROCEDURE - Step 4

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [08/2020 - 12/2021]

    1. for A25A-FXS:

      Refer to PROCEDURE - Step 5

    2. for A25A-FKS:

      Refer to PROCEDURE - Step 2

  6. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH 

    Refer to PROCEDURE - Step 6

  7. REMOVE FRONT DOOR ASSIST GRIP COVER LH 

    Refer to PROCEDURE - Step 7

  8. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) 

    Refer to PROCEDURE - Step 8

  9. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) 

    Refer to PROCEDURE - Step 11

  10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 14

  11. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 17

  12. REMOVE FRONT DOOR FRONT BELT SEAL LH 

    Refer to PROCEDURE - Step 19

  13. REMOVE FRONT DOOR SERVICE HOLE COVER LH 

    Refer to PROCEDURE - Step 23

  14. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 25

  15. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 28

  16. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 
    1. Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH from the front door window regulator sub-assembly LH.
      GTY904354Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals