Removal [12/2021 - ]: Procedure
- REMOVE NO. 1 ROOM LIGHT ASSEMBLY
- Using a screwdriver with its tip wrapped in protective tape, detach the claw and remove the No. 1 room light lens.
Protective Tape - Using a screwdriver with its tip wrapped in protective tape, detach the claw and guide and remove the 2 inner covers.
Protective Tape - Using a screwdriver with its tip wrapped in protective tape, detach the claw as shown in the illustration.
Remove in this Direction Protective Tape - Detach the clamp.
- Disconnect the connector and remove the No. 1 room light housing.
- Using a screwdriver with its tip wrapped in protective tape, detach the claw and remove the No. 1 room light lens.