Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the charge lid courtesy switch removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not performed | Link |
|---|---|---|---|
| Disconnect cable from negative auxiliary battery terminal | Memorize steering angle neutral point | Lane Tracing Assist System | Refer to INITIALIZATION [07/2020 - ] |
| Intelligent Clearance Sonar System*1 | |||
| Simple Advanced Parking Guidance System*1 | |||
| Pre-collision System | |||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [09/2016 - ] |
| () | *1: When performing learning using the Techstream. |