LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Prius Prime Plus >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Service Information) (2 Of 2) >> Back Door Opener Switch >> Inspection [09/2016 - ] >> Procedure

Inspection [09/2016 - ]: Procedure

  1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY 
    1. Check the operation of the opener switch.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        2 - 3 Back door opener switch not pushed 10 kΩ or higher
        2 - 3 Back door opener switch pushed Below 1 Ω

        If the result is not as specified, replace the back door opener switch assembly.

        GTY553938Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Back Door Opener Switch Assembly)
    2. Check the operation of the lock switch. (w/ Smart Key System)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 - 2 Back door lock switch not pushed 10 kΩ or higher
        1 - 2 Back door lock switch pushed Below 1 Ω

        If the result is not as specified, replace the back door opener switch assembly.

scientia non olet · About LEMON Manuals