Customize Parameters [09/2016 - 06/2021]

CUSTOMIZE METER / GAUGE SYSTEM

NOTE:

When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:

The following items can be customized.

Customizing with the Techstream

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Customize Setting / Warning or Display.

Select the setting by referring to the table below.

Warning

Tester Display	Description	Default	Setting	ECU
Reverse Buzzer	Function to change the reverse warning buzzer type	Continual	00:Continual, 01:Single	Combination meter assembly (Meter circuit plate)
Flasher Sound Volume Adjustment	Function to change the flasher sound volume	Medium	10:Large, 00:Medium, 01:Small	Combination meter assembly (Meter circuit plate)

Display

Tester Display	Description	Default	Setting	ECU
ODO Display Time After IG OFF Setting	Function to change the ODO display time after the power switch is turned off	30s	00:30s, 01:60s, 10:600s, 11:OFF	Combination meter assembly (Meter circuit plate)