Malfunction in Water Temperature Warning Light [09/2016 - ]: Procedure
- CHECK CAN COMMUNICATION SYSTEM
- Check if CAN communication system DTCs are output.
Refer to DIAGNOSIS SYSTEM [09/2016 - 01/2018] , or refer to DIAGNOSIS SYSTEM [01/2018 - 05/2019] , or refer to DIAGNOSIS SYSTEM [05/2019 - 07/2020] , or refer to DIAGNOSIS SYSTEM [07/2020 - ]
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
B
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2016 - 12/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2018 - ]
Result:
A
See step 2
- Check if CAN communication system DTCs are output.
- CHECK FOR DTC (SFI SYSTEM)
- Check if SFI system DTCs are output.
Refer to DTC CHECK / CLEAR [09/2016 - ]
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
B
GO TO SFI SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2016 - 01/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [01/2018 - 12/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [12/2018 - 05/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [05/2019 - 07/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [07/2020 - ]
Result:
A
See step 3
- Check if SFI system DTCs are output.
- PERFORM ACTIVE TEST USING TECHSTREAM (INDICAT. LAMP COOLANT HOT)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Perform the Active Test according to the display on the Techstream.
Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Indicat. Lamp Coolant Hot Engine coolant temperature hot warning light OFF or ON - Body Electrical > Combination Meter > Active Test
Tester Display Indicat. Lamp Coolant Hot OK
Engine coolant temperature hot warning light operation is normal.
Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [09/2016 - 07/2020] , or refer to REMOVAL [07/2020 - ]
Result:
NG
REPLACE COMBINATION METER ASSEMBLY (METER CIRCUIT PLATE). Refer to DISASSEMBLY [09/2016 - ]