Problem Symptoms Table [09/2016 - ]
NOTE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
CLOCK SYSTEM
| Symptom | Suspected Area | Link |
|---|---|---|
| Clock display is not displayed | Fuse (ECU-DCC NO. 2, METER-IG2) | - |
| Wire harness or connector | - | |
| Combination meter assembly (Combination meter multi-display) | Refer to DISASSEMBLY [09/2016 - ] | |
| Combination meter assembly (Meter circuit plate) | Refer to DISASSEMBLY [09/2016 - ] | |
| Clock loses or gains time | Combination meter assembly (Meter circuit plate) | Refer to DISASSEMBLY [09/2016 - ] |
| Clock cannot be adjusted | Combination meter assembly (Meter circuit plate) | Refer to DISASSEMBLY [09/2016 - ] |