LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Prius LE AWD-e >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [11/2015 - 12/2018] >> Procedure

Removal [11/2015 - 12/2018]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [11/2015 - 11/2017] , or refer to PRECAUTION [11/2017 - 12/2018]

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
    • If an SRS part is accidentally deployed, it may cause a serious injury.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2015 - 11/2017] , or refer to INITIALIZATION [11/2017 - 12/2018]

  3. REMOVE FRONT DOOR SCUFF PLATE 

    Refer to PROCEDURE - STEP 14

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the front door opening trim weatherstrip.
  5. REMOVE REAR DOOR SCUFF PLATE 

    Refer to PROCEDURE - STEP 18

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the rear door opening trim weatherstrip.
  7. REMOVE LAP BELT OUTER ANCHOR COVER 
    1. Disengage the 3 claws to remove the lap belt outer anchor cover.
      GTY575976Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
      GTY575978Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE LOWER CENTER PILLAR GARNISH 

    Refer to PROCEDURE - STEP 22

  10. REMOVE CENTER PILLAR GARNISH ASSEMBLY 

    Refer to PROCEDURE - STEP 23

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
      GTY575974Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.
      GTY548649Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Locking Button
      *c Release

      HINT: 

      Tape the screwdriver tip before use.

    3. Remove the 2 bolts.
      GTY575971Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 2 guides to remove the front seat outer belt assembly.
  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 
    1. Remove the 2 bolts.
      GTY575972Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.
scientia non olet · About LEMON Manuals