LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Prius LE AWD-e >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (Meter / Gauge / Display - Diagnostic Codes (B1321-B1508) (Except Hybrid)) >> METER / GAUGE SYSTEM (for Gasoline Model) >> DTC B1500-13: Fuel Sender Circuit Open; DTC B1501-13: Sub Fuel Sender Circuit Open [08/2020 - ] >> Description

DTC B1500-13: Fuel Sender Circuit Open; DTC B1501-13: Sub Fuel Sender Circuit Open [08/2020 - ]: Description

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

This DTC is stored when the combination meter assembly detects a fuel sender gauge assembly malfunction via a direct line.

  1. FOR 2WD 

    The fuel sender gauge assembly is connected to the combination meter assembly via direct line. If there is an open or short in the direct line, the combination meter assembly stores DTC B1500-13.

  2. FOR AWD 

    The fuel sender gauge assembly and No. 2 fuel sender gauge assembly are connected to the combination meter assembly via direct line. If there is an open or short in the direct line, the combination meter assembly stores DTC B1500-13 or B1501-13.

    DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
    B1500-13 Fuel Sender Circuit Open Diagnosis Condition:
    • The engine switch is on (IG)
    • IG power source voltage is 9.5 V or more

    Malfunction Status:
    • Voltage signal from fuel sender gauge assembly is 0.2 V or less
    • Voltage signal from fuel sender gauge assembly is 4.7 V or more

    Malfunction Time:
    1. 10 seconds or more
    • Harness or connector
    • Fuel sender gauge assembly
    • Fuel suction tube with pump and gauge assembly
    • Combination meter assembly
    DTC stored -
    B1501-13 Sub Fuel Sender Circuit Open Diagnosis Condition:
    • The engine switch is on (IG)
    • IG power source voltage is 9.5 V or more

    Malfunction Status:
    • Voltage signal from No. 2 fuel sender gauge assembly is 0.2 V or less
    • Voltage signal from No. 2 fuel sender gauge assembly is 4.7 V or more

    Malfunction Time:
    1. 10 seconds or more
    • Harness or connector
    • No. 2 fuel sender gauge assembly
    • Fuel tank vent tube assembly
    • Combination meter assembly
    DTC stored for AWD